Loading

RGB550 Rainbow

Gamemax ARGB series upgraded to ARGB Rainbow lights by built-in controler for get various programmed mode, and it offers Value and Performance scheme. The most suitable cost/performance ratio is the best choice for system builder. 12V CPU power and modern PCIe 6+2pin connectors are ready for high-end gaming system. Fully electrical protection and official safety are also the quality promise by Gamemax.

ARGB Modes Simple Instructions
1. With memory function, It keep last light mode when turn on
2. Press ARGB controller switch to change vairous color mode
3. In any mode, press the RGB controller switch for three seconds, the lights off but fan spin speed by smart IC controlled

  • PSU Type: RGB
  • Cabling: Modular
  • Efficiency: 90+ Gold

Product Introduction
Gamemax RGB series power supply offers “Value and Performance” scheme. The  most  suitable  cost/performance  ratio  is  the  best  choice  for  system builder. 12V CPU power and modern PCIe 6+2pin connectors are ready for high-end gaming system. Fully electrical protection and official safety are also the quality promise by Gamemax.
 Compatible with ATX12V 2.3 &2.4.
 High-end SECC black coating casing.
 High-Efficiency – 90+
 Low Noise 14cm RGB Fan with intelligent fan speed control.
 Honeycomb ventilation design for optimal heat dissipation.
 High-end VGA card support with modern PCIe 6+2pin connector.
 Powerful single +12V rails offer stable DC output and support high-end graphic card and PC system.
 Long cable length at least 500mm supports high-end case with “Bottom”PSU position.
 Active Power Factor rate up to 0.9.
 Green power design that meets ErP requirements.
 Low ripple noise.
 OPP/OVP/UVP/SCP/OCP electrical protection included.
RGB Modes operation instructions:
1. with memory function, turn on power supply again; the initial state is as same as the state of power off;
2. Press RGB controller switch successively, the lights change to be white, blue, yellow, red, green, blue green, purple, breathing lights and color mix mode in turn;
3. Breathing lights mode: make the lights bright gradually in two seconds, make the lights dim gradually in two seconds, play cycle from white color to purple color. 
4. Color mix mode: the lights change from white to purple color in turn and keep 0.5S at peak of each color; it takes 4S between the two colors
5. In any mode, press the RGB controller switch for three seconds, the lights go out.

image.png

111111.gif