Gamemax ARGB series upgraded to ARGB Rainbow lights by built-in controler for get various programmed mode, and it offers Value and Performance scheme. The most suitable cost/performance ratio is the best choice for system builder. 12V CPU power and modern PCIe 6+2pin connectors are ready for high-end gaming system. Fully electrical protection and official safety are also the quality promise by Gamemax.
ARGB Modes Simple Instructions
1. With Various light mode by build-in firmware
2. Press ARGB controller switch to change vairous color mode
3. In any mode, press the RGB controller switch for three seconds, the lights off but fan spin speed by smart IC controlled
- PSU Type： RGB
- Cabling： Modular
- Efficiency： 90+ Gold
Gamemax RGB series power supply offers “Value and Performance”scheme. The most suitable cost/performance ratio is the best choice for system builder. 12V CPU power and modern PCIe 6+2pin connectors are ready for high-end gaming system. Fully electrical protection and official safety are also the quality promise by Gamemax.
⚡【Performance】Honeycomb ventilation design for optimal heat dissipation. 80 plus Gold certified, with 90% efficiency or higher under typical loads. Fully-modular output wire rod, optimize routing requirements.
⚡【Addressable RGB Control】Press RGB controller switch successively, the lights change in o single color mode and breathing lights, color mix mode in turn.
⚡【Highest Protection】Powerful single +12V rails offer stable DC output and support high-end graphic card and PC system. Grade A+ level capacitors offer the highest stability, durability, and reliability, OPP/OVP/UVP/SCP/OCP electrical protection included.
⚡【Our brand】GAMEMAX has been committed to manufacture PC components and provide OEM service for well-known brands from 2003 till now. GAMEMAX\'s products are of multiple international security standard certificates including CB, CCC, FCC, CE, etc. OPP/OVP/UVP/SCP/OCP electrical protection included.
RGB Modes operation instructions:
|Key Function||RGB LED Status|
|Turn On, Entry last Mode||Keep the Save memory mode|
|Press RGB Switch||Select RGB light mode|
|Press and Hold in 3sec||OFF the RGB LED light|
|Press the Switch again||White light flashes once and Entry in o the last mode|
|Press Longer Don't release||Entry Self-Test mode(All led White Light）|
|Release after Press longer||Exit Self-Test mode, Entry Last memory mode|