RGB1050 STD

Gamemax ARGB series upgraded to ARGB Rainbow lights by built-in controler for get various programmed mode, and it offers offers “Value and Performance” scheme. The most suitable cost/performance ratio is the best choice for system builder. 12V CPU power and modern PCIe 6+2pin connectors are ready for high-end gaming system. Fully electrical protection and official safety are also the quality promise by Gamemax.

ARGB Modes Simple Instructions:
1. With Various light mode by build-in firmware
2. Press ARGB controller switch to change vairous color mode
3. In any mode, press the RGB controller switch for three seconds, the lights off but fan spin speed by smart IC controlled

RGB1050Key Features
Compatible with ATX12V 2.3.
High-end SECC black coating casing.
High-Efficiency – 90+ Certified.        
Low Noise 14cm RGB Fan with intelligent fan speed control.
Honeycomb ventilation design for optimal heat dissipation.
High-end VGA card support with modern PCIe 6+2pin connector.
Powerful single +12V rails offer stable DC output and support high-end graphic card and PC system.
Long cable length at least 500mm supports high-end case with “Bottom” PSU position.
Active Power Factor rate up to 0.9.
Green power design that meets ErP requirements.
Low ripple noise.
OPP/OVP/UVP/SCP/OCP electrical protection included.
Safety / EMI Approvals: CE,  CB
RGB Ring Fan on top, RGB Gamemax logo on the side surface, the lights is coming from the top and side

image.png  

GameMax | Computer Case | Power Supply | Cooling Parts | Keyboard | Mouse | VR

Powered by GameMax 7.8 ©2020-2024  GameMax